Программа для диагностики и обслуживания автобусов NEOPLAN

NEOPLAN V10.11 Diagnostic Program

Update Note

Summary

• Добавлены испанский язык, русский язык и корейский язык для NEOPLAN.

Описание программного обеспечения

System Coverage

• (The following models covered are only for reference and will vary constantly with the upgrades of software.)
• Engine Bosch
• Exhaust gas aftertreatment
• Engageable all wheel drive
• Gearbox
• Lock management
• Converter clutch unit
• Management computer
• Auxiliary management computer
• Central on-board computer
• Central on-board computer,bus/coach
• Electronic brake system
• Continuous brake
• Air management
• Cab air suspension strut
• Steered rear axle
• Pivoting joint control
• Instrumention
• Auxiliary air heater,water
• Air conditioning syste
• Auxiliary air conditioning system
• Radio navigation
• Universal mobile phone preparation
• Door control
• Radar sensor
• Lane departure warning system
• Tyre prssure monitor
• Подушка безопасности
• Telematics
• Customer's special module
• MT Gateway
• Energy manager
• Drive motor management
• Ultracap management
• Inverter

Basic Functions

• Read computer information
• Read fault information
• Clear fault information
• Активация тестов механизмов

Special Function

• High-pressure test,Rev-up test
• Compression test
• Cylinder cutoff test
• Injector test,Pressure limiting valve open testHCI system test
• Reset MIL function
• Reset monitoring for excessive regeneration
• Reset monitoring for canceled
• regeneration Particulate filter replacement reset
• Reset pressure differential sensor
• Reset pressure limiting valve
• Read / write IQA data function